BATTERY PLACEMENT - Needed: 2 x AA
Penlite 1,5V (included). We advise you to use good quality
batteries (GP, DURACELL, VARTA). In case you use Rechargeable
batteries; use at least batteries of 1200maH. Make sure the alarm
is off when you place the batteries.
PROGRAM INTO DELKIM RECEIVER – Before you can use the alarm it has to be programmed in your receiver. You do it the same way as you program your alarms. Please read the manual of your receiver how to do it.
For the Rx PLUS Pro this is how you do it:
- STEP 1 - Switch on into L (Local).
- STEP 2 - Press and quickly release programming button once, situated at the bottom right of the receiver back - Channel One LED starts flashing.
- STEP 3 - If programming of the first channel is required, your done, otherwise press and release button to skip to next channel etc… as long as you are on the channel you want.
4: Switch on the smart Alarm, if the alarm is
detected it will be confirmed by a double tone and the next
channel`s LED starts flashing.
COMPLETE PROGRAMMING BY PRESSING AND RELEASING BUTTON THROUGH ALL REMAINING LEDs THE Rx Plus Pro WILL CONFIRM COMPLETION VISUALLY AND AUDIBLY BY CONFIRMING THE FACTORY DEFAULT OR MEMORY SETTINGS.
- STEP 5 - Check that programming has been exactly to your requirements by switching on into either L (Local) or D (Distant) and activating the alarm.
SMART ALARM SIGNAL
When you switch on the alarm, the alarm signal sounds from your DELKIM receiver. This is the unique signal of the alarm. Other signals are “Battery Low” and the “anti theft signal”
Quick programming (video)